RCA RCA MAF85BKR installation manual Mounting the wall plate, Hardware Kit, Drywall Installation

Hardware Kit
(A) M8 x 63 Lag Bolt (x6)	(F) M8 x 12 Bolt (x4)
(B) Lag Bolt Washer (x6)	(G) M8 x 30 Bolt (x4)
(C) Concrete Anchor (x6)	(H) M6 Washer (x4)
(D) M6 x 12 Bolt (x4)	(I) Spacer (x8)
(E) M6 x 30 Bolt (x4)	(J) 3/16” Drill bit

Mounting the wall plate

Drywall Installation

Important! For safety reasons, this mount must be secured to at least two wood studs no less than 16” apart. For displays heavier than 50 kg (110 lbs), three studs are recommended. The studs must be capable of supporting the combined weight of the mount and display.

1.Use a high quality stud fi nder to locate two or more adjacent studs where you wish to install your mount. Mark both edges of each stud to help identify the exact center.

NOTE: You must use the center of each stud to avoid cracking or splitting the wood during installation.

2.Place the wall plate against the wall and level it using the integrated bubble level.

4.Set the wall plate aside and drill a 3/16” pilot hole at each marked location.

5.Place the wall plate back against the wall and attach it using the lag bolts (A) and lag bolt washers

(B) (see Fig. 2). Do not over-tighten these bolts and do not release the wall plate until all bolts are in place. Ensure that the wall plate remains level after all bolts are secured.

3.While another person holds the wall plate in position, mark four or six locations (two per stud) for securing the mount to the wall (see Fig.1).

Fig.1

2