RCA RCU450 manual Code Search Methods, Manual Code Search

Code Search Methods

If your component’s brand isn’t listed in the Code List or you have tried all of the codes for your brand and the remote does not operate your component, use one of the Code Search methods below—Manual Code Search or Auto Code Search. Both Code Search methods search all of the codes because your component’s code may be listed under another brand in the code list.

Note: The Code Search method may take a long time because the remote searches all of the codes in its memory for the code which operates your component. Therefore, if your brand is listed in the Code List, use the Direct Entry method described on pages 5-8.

CODE

SEARCH

ON•OFF

ENTER

Manual Code Search

1.Manually turn on the component you want the remote to operate.

2.Press and hold the CODE SEARCH key for approximately three seconds until all four component keys light up. Then release the CODE SEARCH key.

3.Press and release the component key that corresponds to the component you want the remote to operate (TV, VCR or DBS•CABLE). The chosen component key remains lit.

Note: For DVD or AUX, press DVD•AUX, then the component key corresponding to the component to be stored under the AUX key. For DVD, press DVD•AUX, then the VCR key. For an auxiliary component, press DVD•AUX, then the corresponding component key (TV, VCR,

DBS•CABLE).

4.Aim the remote at the component and press the ON•OFF key continuously until the component turns off. The component key remains lit during this process, blinking each time you press the

ON•OFF key.

Important: Because there are so many codes, you may have to press the ON•OFF key many times—possibly up to 200 times.

5.When the component turns off, press the ENTER key immediately to store the code. The lighted component key then turns off.

6.Use Code Retrieval on the next page to identify the code for your component for future reference.

9