Recoton/Advent AW810 Adjust the Transmitter, Set the Frequency Control Wheel J to its midpoint

ADJUST THE TRANSMITTER

Adjust the transmitter as follows.

Step 1 Turn ON your Audio Source (i.e. Stereo Receiver, TV, etc.) so that you can hear sound coming from the source.

Step 2 Pivot the Antenna (L) to the upright, vertical position.

Step 3 Set the Transmitter “Level”

1.Set the Frequency Control Wheel (J) to its midpoint.

2.Turn the Output Level Control Wheel (G) all the way to the left (your left when looking at the transmitter controls),

as shown.

3.Check status of Audio Level Indicator Light (F). If it flickers intermittently (about half the time), proceed to

TUNE THE SPEAKERS.

4.If Audio Level Indicator Light is on solid red or flickering very rapidly, turn Output Level Control Wheel slowly back to the right until light flickers intermittently.

Audio Level

Indicator Light (F)

OUTPUT LEVEL	AUDIO IN		TUNING	DC 18V
	R	L	CHARGE

Output Level	Frequency
Control Wheel (G)	Control Wheel (J)
(Turn to Left)

Note: If the light does not flicker, confirm secure connection of the AC Adapter. If the light still does not flicker, confirm secure connection to the audio source output. If, there is still no response, leave the Output Level Control Wheel completely to the left (as shown) and see the following Note.

Note: If the transmitter is connected to a variable output (i.e. headphone jack, TV audio out) on the audio source, leave the Output Level Control Wheel turned all the way to the left (as shown) and adjust the volume on the audio source up or down as necessary to make the Audio Level Indicator Light flicker intermittently. If you are unclear as to the kind of output (variable or fixed) you are using, please see MORE HELPFUL INFORMATION on following page.

6