8. Operation

OP1

OP2(1)

STARTING ENGINE

WARNING

The cutting head will start rotating upon the engine starts.

1.

Rest the unit on a flat, firm place. Keep the

 

cutting head off the ground and clear of

 

surrounding objects as it will start rotating upon

 

starting of the engine.

2.

Push the primer pump several times until

 

overflown fuel flows out in the clear tube. (OP1)

OP3 (5)

(6)

(4)

(7)

(2)

(3)

BCZ2600S

BCZ2600SU

3.

Move the choke lever to the closed position.

 

(OP2)

4.

Set the ignition switch to the “start” position.

 

While pulling the throttle lever, push the set

 

button, and release the throttle, then the throttle

 

lever is in to the “start” position. (OP3)

5.

While holding the unit firmly, pull out the starter

 

rope quickly until engine fires. (OP4)

(1)choke lever (2) close (3) open

(4)ignition switch (5) start (6) stop

(7)throttle set button

IMPORTANT

(4)

(7) (6)

(5)

BCZ2600SW

OP4

Avoid pulling the rope to its end or returning it by releasing the knob. Such actions can cause starter failures.

6.Move the choke lever downward to open the choke. And restart engine. (OP2)

7.Allow the engine to warm up for a several minutes before starting operation.

NOTE

1.When restarting the engine immediately after stopping it, leave the choke open.

2.Overchoking can make the engine hard to start due to excess fuel. When the engine failed to start after several attempts, open the choke and repeat pulling the rope, or remove the spark plug and dry it.

18

Page 18
Image 18
RedMax BCZ2600SU, BCZ2600SW manual Operation, OP1, Starting Engine, OP4,  18 