6. Set up (EX2-BC only)
EX2-BC SE1
EX2-BC SE2
EX2-BC SE3
■INSTALLING DEBRIS GUARD
•Put the debris guard on the gear box, attach it with the 2 screws and hardware provided. (SE1)
■INSTALLING CUTTING HEAD (SE2)
1.While locking the gear shaft, by inserting the supplied tool into the upper holder on the gear box, loosen and remove the hexagon nut(left- handed)
2.Then screw in the cutting head to the gear shaft over the holders.
■BALANCE UNIT
1.Put on strap and attach unit to strap.
2.Slide clamp up or down until unit balances with head just touching on the ground. (SE3)
