GZ3500T
9. Maintenance
WARNING
Before cleaning, the inspecting or repairing the unit, make sure that engine has stopped and is cool. Disconnect the spark plug to prevent accidental starting.
■MAINTENANCE AFTER EACH USE
1. Air filter
Loosen the knob and remove the air cleaner cover. Take off the filter elements and tap off attached sawdust. When they are extremely dirty, shakewash with soapy water. Do not use gaso- line. Dry them completely before reinstalling.
knob
air cleaner cover
filter elements
2. Oiling port
WARNING
When installing the filter, do not pinch or fold the suction pipe.
3. Oil filter
1.With a wire hook, take out the oil filter from the feeding port.
Oil filter
2. Wash the filter with
WARNING
When installing the filter, do not pinch or fold the suction pipe.
Remove the guide bar and check the oiling port for clogging.
Oiling port
3. Guide bar
When the guide bar is removed, remove sawdust in the bar groove and the oiling port.
<Type : sprocket nose>
Grease the nose sprocket from the feeding port on the tip of the bar.
Grease port
Oiling port | Sprocket |
4. Spark plug
(0.24~0.28inch)
NGK
CMR7H
Clean the electrodes with a wire brush and reset the gap to 0.6 mm~0.7mm (0.24~0.28inch) as necessary.
5. Sprocket | 0.2inch (0.5mm) |
|
Check for cracks and for excessive wear interfering with the chain drive. If the wear is considerable, replace it with new one. Never fit a new chain on a worn sprocket, or a worn chain on a new sprocket.
4. Others
Check for fuel leakage and loose fasteners and damage to major parts, especially handle joints and guide bar mounting. If any defects are found, make sure to have them repaired be- fore operating the saw again.
■PERIODICAL SERVICE POINTS
1. Cylinder fins
1.Remove the starter case.
2.Remove sawdust between the
cylinder fins.
3. Clean the inside of the starter case.
2. Fuel filter
(a) Using a wire hook, pull out the filter from the filter port.
Fuel filter
6. Way of the cooling air
WARNING
•The engine metal parts can burn your skin. Never touch the cylinder, muffler or ignition plug etc. during operation or right after stopping the engine.
•Before starting the engine, check around the muffler and remove sawdust. If you do not, it will cause the overheating. Keep clean area around the muffler.
This engine is
inlet port of the cooling air
IMPORTANT
(b)If dirty, replace filter.
Replace with new one if clogged with dirt.
When installing the cylinder cover, make sure that switch wires and grommets are positioned correctly in place.