9. Maintenance
MA19
MA20
MA21
NOTE
In case irregular wear is observed on a recoil boss or reel bore, exchange for new components.
5.Remove the rope from the reel.
6.Make a knot in end of new rope and lead it through a reel hole from outside. Pull the rope hard to engage the knot into a reel pit and put end of the knot into a reel notch. (MA19)
(1) Notch
IMPORTANT
In case the rope knot is too large or the rope end is protruded from the reel, the rope retraction may become difficult.
7.After leading the rope through a guide of recoil case, align a notch in the back of reel with end of the coil spring. Assemble a spacer and the reel to the recoil boss. By turning the reel left and right, engage the reel notch with the spring end.
8.Put a washer on the recoil boss and fix the screw as original.
9.Lead the rope through a guide hole on the starter case, starter knob and a washer and make a knot (double overhand knot). (MA20)
10.Pull out the rope from a notch in the reel rim and turn the reel 4~5 turns clockwise. (MA21)
(1) Notch
11.Holding the reel with left hand, pull out the rope with right hand. Ease the left hand and let the
29
