8. Operation
OP8
(1)
OP9
20
■ADJUSTING IDLING SPEED (OP8)
1.When the engine tends stop frequently at idling mode, turn the adjusting screw clockwise.
2.When the cutting head keeps rotating after releasing the trigger, turn the adjusting screw
(1) idle adjusting screw
NOTE
•Warm up the engine before adjusting the idling speed.
■HOW TO USE
WARNING
1Always wear eye protection such as safety goggles. Never lean over the rotating cutting head. Rocks or other debris could be thrown into eyes and face and cause serious personal injury.
2Keep the blade guard and the mad guard attached in place at all times when the unit is operated.
3Before starting a job, check the area and remove all obstacles and objects that could be thrown by the blade.
4Do not adjust the wheel height or try to remove anything entangled to the blade with the engine running.
1Before starting the engine, adjust the wheel height for desired cutting depth(See page 18).
2Before starting a job, plan your direction of travel so that you can always hold the edger on you right side and can walk on a hard surface as much as possible.
3When starting to edge, run the engine at full throttle, and slowly have the blade cut into the edge groove.
NOTE
•Do not use the HEZ2500S to make a new groove into the ground. Such usage will not be covered by RedMax Warranty.
