RedMax CHTZ2401-CA, CHTZ2401L-CA manual Operation, OP22, English

English

7. Operation

OP1

(1)

OP2(2)

(4) (3)

OP3 (7) (6) (5)

(8)

(6)

(7) (5)

(8)

OP4

[HTZ2401] [HTZ2401-CA]

[CHTZ2401] [CHTZ2401-CA]

■STARTING ENGINE

WARNING

•The cutting head will start moving upon the engine starts.

1.Feed fuel into the fuel tank and tighten the cap securely.

2.Rest the unit on a flat, firm place. Keep the cutting head off the ground and clear of surrounding objects as it will start moving upon starting of the engine.

3.Push the primer pump several times until overflown fuel flows out in the clear tube. (OP1)

4.When the engine is cool, move the choke lever to the closed position. (OP2)

(1)primer pump

(2)choke lever

(3)close

(4)open

(5)ignition switch

(6)RUN

(7)STOP

(8)throttle lever

5.Set the ignition switch to the “RUN” position. Release the throttle lever and make sure it is fully back. (OP3)

6.While holding the unit firmly, pull out the starter rope quickly until engine fires. (OP4)

IMPORTANT

•Avoid pulling the rope to its end or returning it by releasing the knob. Such actions can cause starter failures.

7.Move the choke lever to the open position. And pull out the starter rope quickly to restart engine.

8.Allow the engine to warm up for a several minutes before starting opertion.

NOTE

1.When restarting the engine immediately after stopping it, leave the choke open.

2.Overchoking can make the engine hard to start due to excess fuel. When the engine failed to start after several attempts, open the choke and repeat pulling the rope, or remove the spark plug and dry it.

24