SRTZ2460F
6. Set up
■ MOUNTING ENGINE (SE1) | ■ BALANCE UNIT |
SE1 |
1.Push the driveshaft housing toward the clutch housing and rotate it by hand to check that the driveshaft is engaged with the gears.
2.Insert the driveshaft housing into the clutch housing until it bottoms, and align the positioning holes on the clutch housing and the shaft tube and install the screw. When difficult to engage, twist the engine slightly.
3.Fasten the clamp securely with two screws.
1.Put on strap and attach unit to strap.
2.Depending on the working posture, slide clamp up or down until unit balances and the strap fits your body.
IMPORTANT
Tighten the screws gradually by turns.
SE2 |
■CONNECTING THROTTLE WIRE
1. Remove the air cleaner cover.
2. Connect the end of the throttle wire to the joint on the top of the carburetor. (SE2)
■CONNECTING SWITCH WIRES
•Connect the switch wires between the engine and the main unit. Pair the wires of the same color.
SE3 |
(1) |
SE4 |
|
| (1) |
(3) | (2) |
| |
(4) | (5) |
|
■INSTALLING HANDLE
•Mount the handle to the shaft tube and clamp it at a location that is comfortable to you. (SE3)
(1) About 19 inches (48cm)
■ATTACHING THE TRIMMING MECHANISM (SE4)
1.Remove the screw screwed into the end of the trimming mechanism.
2.Insert the end of the trimming mechanism into the shaft tube.
3.Line up the hole on the end of the trimming mechanism into which the screw is to be inserted with the hole on the shaft tube, and screw the screw firmly in.
4.Using a wrench, screw in the bolt provided to fix the trimming mechanism into place.
(1)Shaft tube
(2)Trimming mechanishm
(3)Screw hole
(4)Bolt
(5)Fastening bolt
