17.Attach the Headrest (20) to the Headrest Frame (9) with two M6 x 18mm Button Screws (55), an M6 x 55mm Button Screw (56), and three M6 Washers (62).
Attach the Backrest (21) to the Backrest Frame (8) in the same way.
18.Attach a Handle (12) to the Left Frame (4) with two M10 x 80mm Button Bolts (52), two M10 Curved Washers (79), and two M10 Nylon Locknuts (65).
Attach the other Handle (12) in the same way.
Make sure that all parts are properly tight- ened before you use the inversion table.
WARNING:
HOW TO LOCK THE INVERSION TABLE FOR STORE DISPLAY OR TO PREVENT UNSUPERVISED USE
When the inversion table is displayed in a store, or when it is not in use, it should be locked to prevent unsupervised use. First, insert the threaded end of the Lock Pin (50) into the Support Leg (13), and position the other end of the Lock Pin on top of the Leg Frame (10). Then, tighten an M10 Nylon Locknut (65) onto the Lock Pin.
17 | 9 | |
20 | ||
62 | ||
| ||
| 56 | |
| 55 | |
21 | 62 | |
| ||
8 |
| |
18 |
| |
12 |
| |
| 12 | |
| 65 | |
| 65 | |
| 4 | |
| 79 | |
| 52 | |
65 |
| |
| 13 | |
10 | 50 | |
12 |
|