2.While another person lifts the rear of the Frame (1), attach the Rear Stabilizer (30) to the Frame with two M10 x 105mm Button Screws (89).
3.Identify the Ramp Axle (39), which is the longest axle. Next, identify the Ramp Axle Covers (41), which are smaller than the Wheel Covers (not shown). Slide a Ramp Axle Cover onto an M6 x 16mm Button Screw (103) as shown. Tighten the Button Screw into one end of the Ramp Axle. Apply a small amount of the included grease to the Ramp Axle.
Have a second person hold the two Ramp Bushings
(40)against the indicated tubes on the Frame (1). Align the tubes on the Ramp (33) with the Ramp Bushings; make sure that the Ramp is turned as shown. Insert the open end of the Ramp Axle (39) into the Ramp, the Ramp Bushings, and the Frame. If nec- essary, tap the Ramp Axle with a rubber mallet to insert it.
Slide the other Ramp Axle Cover (41) onto an M6 x 16mm Button Screw (103) as shown. Tighten the Button Screw into the open end of the Ramp Axle (39).
4.Slide an M6 Washer (102) onto an M6 x 16mm Button Screw (103). Tighten the Button Screw into one end of the Lift Axle (38). Apply a small amount of grease to the Lift Axle.
Raise the Ramp (33). Insert the Lift Axle (38) into the welded tube under one side of the Ramp, through the motor screw, and then into the welded tube under the other side of the Ramp. As you insert the Incline
Axle through the motor screw, make sure that the motor screw does not turn.
Slide an M6 Washer (102) onto an M6 x 16mm Button Screw (103). Tighten the Button Screw into the open end of the Lift Axle (38).
2 |
|
|
|
| 30 |
| 1 |
|
|
| 89 |
3 |
|
|
|
| Tubes |
33 | 103 | |
| ||
Grease | 41 | |
| 39 |
|
103 |
|
|
|
| 40 |
41 |
| |
| 40 | Tubes |
|
| 1 |
4 |
|
|
| 33 |
|
| Motor |
|
| Screw |
|
103 | 38 | 103 |
|
| |
102 | Grease | 102 |
| ||
6
