6 Measure your heart rate, if desired.
Note: If the metal contacts on the pulse sensor are covered with thin sheets of plastic, remove the plastic.
To use the pulse sensor, place your hands on the metal
contacts. Your palms must be touching the contacts closest to you and your fingers
must be touching the opposite contacts. Avoid moving your hands or squeezing the contacts too tightly. After a moment, the heart indicator in the display will begin to flash and then your heart rate will be shown. For the most accurate heart rate reading, continue to hold the contacts for about 15 seconds.
7 Whenpoweryou are finished exercising, turn off the
To turn off the power, simply wait for a few minutes. If the pedals are not moved and the console buttons are not pressed for a few min- utes, the power will turn off automatically.
HOW TO USE A PRESET PROGRAM
1 Begin pedaling to activate the console.
Refer to step 1 on page 9.
2 Set a heart rate goal, if desired.
Refer to step 2 on page 9.
3 Select one of the preset workout programs
Each time the power is turned on, the manual program will be selected. To
select one of the preset programs,
press the Program button repeatedly until a
As you select each | Matrix | |
preset program, the | ||
| ||
matrix will show the |
| |
resistance settings of |
| |
the program you |
| |
have selected. If you |
|
select program 2, for example, the matrix will show that the resistance will gradually increase during the first half of the program and then grad- ually decrease during the last half of the program.
4 Follow your progress with the console display.
As you exercise, | Matrix |
follow your progress | |
with the matrix on |
|
the left side of the |
|
display. During the |
|
first minute of the |
|
program, the first column of the matrix will flash. During the second minute, the second column will flash, and so forth. In addition, the resistance of the pedals will automatically change according to the height of the flashing
Note: If the program is too easy or too difficult, press the Resistance + or – button to adjust the intensity level of the program. Each time you press a button, the height of all of the columns in the matrix will increase or decrease.
In addition to the matrix, the display will show your pedaling speed, the number of Calories you have burned, the elapsed time, and the distance you have pedaled. The display will also show your heart rate when you use the pulse sensor.
5 Measure your heart rate, if desired.
Refer to step 6 at the left.
When you are finished exercising, turn off the
6 power.
Refer to step 7 at the left.
10
