4.While another person holds the Handlebar (7) near the Handlebar Post (6), feed the Upper Wire Harness (16) and the Pulse Sensor Wire (45) up through the indicated hole in the Handlebar. Attach the Handlebar to the Handlebar Post with three M8 x 25mm Button Screws (19) and three M8 Split Washers (28).
5.The Console (9) requires four “D” batteries (not included); alkaline batteries are recommended. Press the indicated tab on the battery cover and remove the cover. Press four batteries into the bat- tery clips; make sure that the batteries are orient- ed as shown by the markings inside of the bat- tery clips. Then, reattach the battery cover.
6.Insert the Bookrack (8) into the slots in the Console
(9). Attach the Bookrack to the Console with two M4 x 25mm Screws (20). Be careful not to pinch the wires in the Console.
7.While another person holds the Console (9) near the Handlebar (7), connect the Pulse Sensor Wire (45) and the Upper Wire Harness (16) to the corre- sponding wires on the Console.
Insert all excess wiring down into the Handlebar Post (6). Attach the Console (9) to the Handlebar
(7)with four M4 x 16mm Screws (21). Be careful not to pinch the Pulse Sensor Wires (45) or the Upper Wire Harness (16).
6
4 |
|
|
|
| Hole |
|
| 45 |
| 6 | 7 |
|
| |
28 |
|
|
19 |
| 16 |
| 28 | |
|
| |
|
| 19 |
5 |
|
|
|
| 9 |
Battery |
|
|
Cover |
|
|
|
| Batteries |
6 |
|
|
|
| 8 |
|
| 9 |
20 |
|
|
7 |
|
|
|
| 9 |
| 7 |
|
21 |
| Console |
|
| |
| 45 | Wires |
| 16 | |
|
| |
|
| 21 |
|
| 6 |
