Reebok Fitness RBEX49840 manual Washers may be pre-attached to the Seat

8.	Attach the Seat (12) to the Seat Post (11) with four	8
	M8 Nylon Locknuts (56) and four M8 Split Washers
	(28). Note: The Nylon Locknuts and Split		12
	Washers may be pre-attached to the Seat.
	Turn the Seat Knob (31) counterclockwise two or
	three turns to loosen it. Next, pull the Knob, insert
	the Seat Post (11) into the Frame (1), and then	11
	release the Knob. Slide the Round Collar (13) down
	the Seat Post and press it into the Frame. Attach		28
	the Round Collar to the Frame with an M6 x 8mm	13
	Screw (26). Move the Seat Post up and down
	slightly until the pin on the Knob snaps into one
	of the holes in the Seat Post. Then, turn the Knob
	clockwise until it is tight.
		1	56
			26
			31
9.	Identify the Left Pedal (40); the threaded shaft on	9
	each Pedal is marked with an “L” for “left” or an “R”
	for “right.” Using an adjustable wrench, firmly tight-
	en the Left Pedal counterclockwise into the Crank
	Assembly (33). Tighten the Right Pedal (not shown)
	clockwise into the Crank Assembly. Important:
	Tighten both Pedals as firmly as possible. After	33
	using the exercise cycle for one week, retighten
		41
	the Pedals. For best performance, the Pedals
	must be kept tightened.	40
	Identify the Left Pedal Strap (41), which is marked
	with an “L.” Attach the Left Pedal Strap to the Left
	Pedal (40), and adjust the Left Pedal Strap to the
	desired position. Attach and adjust the Right Pedal
	Strap (not shown) in the same way.
10.	Attach the Water Bottle Holder (63) to the Frame (1)	10
	with two M4 x 19mm Screws (59). Note: The water
	bottle holder is designed to be used with your own		63
	water bottle.	59
			1

11.Make sure that all parts are properly tightened before you use the exercise cycle. Note: Some hard- ware may be left over after assembly is completed. Place a mat under the exercise cycle to protect the floor or carpet.

7