Reebok Fitness RBTL09104C.0 manual Troubleshooting, Problemsolution, Power does not turn on

TROUBLESHOOTING

Most treadmill problems can be solved by following the steps below. Find the symptom that applies, and follow the steps listed. If further assistance is needed, see the front cover of this manual.

PROBLEMSOLUTION

1.The power does not turn on

a.Make sure that the power cord is plugged into a surge suppressor, and that the surge suppressor is plugged into a properly grounded outlet (see page 8). Use only a single-outlet surge suppressor that meets all of the specifications described on page 8. Important: The treadmill is not compatible with GFCI-equipped outlets.

b.Make sure that the key is fully inserted into the console.

c. Check the reset/off circuit breaker located on the frame near the power cord. If the switch protrudes as shown, the circuit breaker has tripped. To reset the circuit breaker, wait for five minutes and then press the switch back in.

Tripped Reset

2.The power turns off during use

a.Check the circuit breaker located on the treadmill frame near the power cord (see 1. c. above). If the circuit breaker has tripped, wait for five minutes and then press the switch back in.

b.Make sure that the power cord is plugged in. If the power cord is plugged in, un- plug it, wait for five minutes, and then plug it back in.

c.Remove the key from the console and then reinsert it.

d.Make sure that the reset/off circuit breaker is in the on position (see 1. d. above).

e.If the treadmill still will not run, see the front cover of this manual.

3.The walking belt a. Use only a single-outlet surge suppressor that meets all of the specifications de-

slows when walked	scribed on page 8.
on
	b. If the walking belt is overtightened, tread-	b	7–10 cm
	mill performance may decrease and the
	walking belt may be permanently dam-
	aged. Remove the key and UNPLUG THE
	POWER CORD. Using the included allen
	wrench, turn both rear roller adjustment
	bolts counterclockwise 1/4 of a turn.
	When the walking belt is properly tight-
	ened, you should be able to lift the edges	Rear Roller Adjustment Bolts
	of the walking belt 7 to 10 cm (3 to 4 in.)
	off the walking platform. Be careful to
	keep the walking belt centered. Plug in the power cord, insert the key and run the
	treadmill for a few minutes. Repeat until the walking belt is properly tightened.
	b. If the walking belt still slows when walked on, see the front cover of this manual.

26