Reebok Fitness RBTL09506.0 manual Assembly, Make sure that the power cord is unplugged

ASSEMBLY

Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials. Do not dispose of the packing materials until assembly is completed.

Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This is a normal condition and does not affect treadmill performance. If there is lubricant on top of the walking belt, simply wipe off the lubricant with a soft cloth and a mild, non-abrasive cleaner.

Assembly requires the included hex key and your own phillips screwdriver , rubber

mallet , and adjustable wrench . For help identifying the assembly hardware, see the drawings below. The number in parentheses below each drawing is the key number of the part, from the PART LIST on pages 30 and 31. The number following the parentheses is the quantity needed for assembly.

Note: Some small parts may have been preassembled. If a part is not in the parts bag, check to see if it has been preassembled. To avoid damaging plastic parts, do not use power tools for assembly. Extra hard- ware may be included.

5/16” Star	3/8” Star		Extension Leg
Washer (99)–4		Nut (20)–2	Nut (91)–4
	Washer (67)–4
3/4” Screw (7)–6	Base Cover Screw (63)–4
			Latch Bolt (101)–2
1” Tek Screw (82)–8	Console Bolt (72)–4		Extension Leg Bolt (87)–4

1. Make sure that the power cord is unplugged.	1
With the help of a second person, carefully tip
the treadmill onto its side as shown. Partially fold
the Frame (55) so that the treadmill is more sta-		Bracket	85
ble. Do not fully fold the Frame until the
treadmill is completely assembled.		99
Insert an Extension Leg (97) into the indicated	87
bracket on the base of the Uprights (85). Make
sure that the Extension Leg is turned so the Base
Pad (81) is on the side shown. If necessary, use
a rubber mallet to align the holes in the			91
Extension Leg with the holes in the bracket.
Attach the Extension Leg (97) with two Extension		97
Leg Bolts (87), two 5/16" Star Washers (99), and		81
two Extension Leg Nuts (91) as shown. Firmly	55
tighten the Extension Leg Bolts.
	6