Reebok Fitness RBTL09506.0 manual Sleeve to make sure it is locked into Place

5. Identify the Latch Assembly (76). Make sure that
	5
the sleeve has been slid over hole 1 and that the
Latch Knob (46) is locked into hole 1. Pull on
the sleeve to make sure it is locked into
place.

		Hole 2	46
Next, make sure that the Latch Knob (46) is
locked into hole 2. If it is not, pull out the tube				Hole 1
until you see hole 2 and then slide the tube back	Tube
in until the Latch Knob locks into hole 2.
		Sleeve
				76
6. Remove the plastic ties from the ends of the	6
Latch Assembly (76).
		55
Orient the Latch Assembly (76) so that the large
barrel and the Latch Knob (46) are in the posi-
tions shown; make sure that all of the holes are		20	101	Top
aligned (see the inset drawings). Attach the
lower end of the Latch Assembly to the bracket				Holes
in the center of the Uprights (85) with a Latch			76
Bolt (101) and a Nut (20).
	46
Then, attach the upper end of the Latch			Large
Assembly (76) to the bracket on the Frame (55)
			Barrel
with a Latch Bolt (101) and a Nut (20). Note: It
may be necessary to move the Frame back and			85
forth to align the Latch Assembly with the
				Holes
Bracket.
Lower the Frame (55) (see HOW TO LOWER		20		Bottom
THE TREADMILL FOR USE on page 26).			101
7. Identify the Left Base Cover (88), which has	7
cutouts in the locations shown. Slide the Left			85
Base Cover onto the left Upright (85). Slide the			Left	Right
Right Base Cover (86) onto the right Upright.
Identify the Left Upright Sleeve (77) and the Right			77
Upright Sleeve (9). Slide the Upright Sleeves onto
the Uprights (85) as shown.	Cutouts		88	9
				86
	8