PROBLEM: The walking belt is
SOLUTION: a. If the walking belt has shifted to the left, first re- move the key and UNPLUG THE POWER CORD. Using the allen wrench, turn the left rear roller bolt clockwise 1/2 of a turn. Be careful not to overtighten the walking belt. If the walking belt has shifted to the right, turn the left rear roller bolt counterclockwise 1/2 of a turn. Plug in the power cord, insert the key and run the treadmill for a few minutes. Repeat until the walking belt is centered.
a
b. If the walking belt slips when walked on, first remove
the key and UNPLUG THE POWER CORD. Using b the allen wrench, turn both rear roller bolts clockwise,
1/4 of a turn. When the walking belt is correctly tight- ened, you should be able to lift each side of the walk- ing belt 3 to 4 inches off the walking platform. Be careful to keep the walking belt centered. Plug in the power cord, insert the key and carefully walk on the treadmill for a few minutes. Repeat until the walking belt is properly tightened.
PROBLEM: The
SOLUTION: a. Remove the key from the console and unplug the | a |
| Top View |
power cord. Remove the screws from the hood and |
| ||
|
|
| |
carefully remove the hood. Locate the Reed Switch |
|
| 11 |
(17) and the Magnet (12) on the left side of the Pulley |
|
| |
|
|
| |
(11). Turn the Pulley until the Magnet is aligned with |
| 26 | 12 |
the Reed Switch. Make sure that the gap between |
| ||
the Magnet and the Reed Switch is about 1/8”. If |
| 17 |
|
necessary, loosen the Reed Switch Screw (26) and |
| 1/8” |
|
move the Reed Switch slightly. Retighten the Screw. |
|
| |
|
|
| |
|
|
| |
minutes to check for a correct speed reading. |
|
|
|
PROBLEM: Bubbles form in the walking belt
SOLUTION: a. Due to variations in humidity and temperature, there is a possibility that bubbles may form in the walking belt. Although the bubbles will disappear with time, you may unplug the power cord, carefully insert a needle into the bubbles (a), and push the air out of the bubbles (b).
a.
b.
27
