2.Attach the Latch Housing (89) to the Left Upright (90) with two Latch Bolts (77). Do not overtighten the Latch
Bolts.
3.Have a second person hold the Handrails (114) near the Right and Left Uprights (90, 95). Feed the Upright Wire Harness (108) down into the Right Upright, and pull the end of the Upright Wire Harness out of the lower end of the Upright. Set the Handrail on the Uprights.
Finger tighten eight Upright Bolts (86) and four 3/8” Star Washers (88) into the Uprights (90, 95) and the Handrail (114) as shown. Do not tighten the Upright Bolts yet.
Be careful to avoid pinching the Upright Wire Harness (108).
Note: The CD Holder (122) and the Cup Holder (123) are replaceable. If these parts become dislodged from the Console Base (80), simply press them back in.
4.Connect the Upright Wire Harness (108) to the Base Wire Harness (115) in the bracket on the Base (99).
Make sure to connect the connectors properly (see the inset drawing); the connectors should slide to- gether easily and snap into place. If the connectors do not slide together easily and snap into place, turn one connector and try again to connect them. IF THE CON-
NECTORS ARE NOT CONNECTED PROPERLY, THE CONSOLE MAY BE DAMAGED WHEN THE POWER IS TURNED ON.
Insert the excess Upright Wire Harness (108) and Base Wire Harness (115) up into the Right Upright (95).
2 |
|
|
|
|
|
|
| 90 |
|
| 89 |
|
|
|
77 |
|
|
|
|
3 |
|
|
|
|
| 122 |
|
|
|
86 |
|
| 80 |
|
|
|
|
| |
|
|
| 123 |
|
|
| 88 |
|
|
|
| 86 |
| |
114 |
|
|
|
|
| 90 | 114 | 88 | 86 |
|
| |||
|
|
|
| |
|
|
| 95 |
|
|
|
| 108 |
|
4 |
|
|
| 95 |
|
|
| 99 |
|
|
|
| 108 |
|
|
|
| 115 |
|
7
