Regency L900-1 Installation, CONVERSION KIT #547-969FROM NG TO LP, LP Conversion Kit Contains

INSTALLATION

CONVERSION KIT #547-969 FROM NG TO LP

THIS CONVERSION MUST BE DONE BY A QUALIFIED GAS FITTER, IF IN DOUBT DO NOT DO THIS CONVERSION!!

INSTALLATION

LP Conversion Kit Contains:

Qty.	Part #	Description
1	910-582	LP Conversion Coil
1	910-037	LP Pilot Orifice
1	904-431	Orifice #49
1	904-529	Allen Key
1	918-590	LP Conversion Decal
1	908-528	Red Propane Label

1918-734 Instruction Sheet

1)Remove the right side mesh by gathering the mesh together and lifting the curved end of the rod up and out of the bracket located on the top right of the glass frame.

Now slide the straight end of the rod out from the bracket located on the middle inside top of the outer shell. Repeat for left side.

2)Remove the front cover plate by lifting up off of the pins on the left and right side of the firebox.

Front Cover Plate Right Side Pin Shown

3)Remove the glass door.

a.Release the 2 door latches on the left and right side at the top of the firebox.

b.Swing the door out from the top and release the hinge on the left side of the door and lift out.

HingeDoor

c.Place the door on a soft surface to prevent scratching.

4)Remove the grate by undoing the 4 screws, 2 on each side.

Latch Location

Latch

Grate

5) Remove the burner tube by removing the 2 screws.

Right Side Rod with Screen Removed

Burner Tube

28 Regency® L900-1 Direct Vent Gas Fireplace