INSTALLATION
FRONT DOOR
INSTALLATION
(packaged separately)
1)Open the two side panels.
2)Slide the door
onto the two hinge pins making sure the two pieces are flush to- gether. See di- agram 1.
3) Close the door. The latch plate must
be centered around the alignment pin. See dia- gram 2. If the latch plate interferes with the cor- ner of the stove you may want to angle the
plate slightly so the door closes easier.
4)The latches should already be at the proper setting. If they are too hard or too easy to close, you may want to adjust them by loosening the latch catch. See diagram 3.
LOUVER
INSTALLATION
1)Attach the top & bottom louvers to the side stove panel using 2 screws per side.
TEST FOR FLUE
SPILLAGE
Note: If the flue is blocked or has a strong reverse flow, the thermally actuated safe- ty switch mounted in the draft hood will automatically shut off the gas supply within about 10 minutes. If the heater turns off because of this during the spill- age test, check for the cause of the lack of draft.
A "spillage" test must be made before the installed unit is left with the customer. Follow the procedure below:
1)Start all exhaust fans in the home and any other gas appliances. Then close all doors and windows.
The thermally activated safety switch must be manually reset before first star- tup.
Diagram 2
5)Remove the blue plastic protective coating from the glass.
6)Test the seal around the door by placing a piece of paper between the unit and the door, close the door and try to pull the paper out. If it slips out easily, then the door is not properly sealed. Tighten or loosen the latch. See diagram 3.
2)Light the unit and set controls to maximum.
3)After five minutes, test that there is a "pull" on the flue by placing a smoke match, cigarette or similar device which gives off smoke, on the edge of the draft hood. See diagrams.
OPTIONAL WALL
THERMOSTAT
A wall thermostat may be installed if desired. Connect the wires as per the wiring diagrams. Note that the wires are connected to the "TH" on the gas valve. Use table below to determine the maximum wire length:
Note: Preferable if the thermostat is in- stalled on an interior wall.
Regency offers an optional programmable ther- mostat but any
Diagram 3 |
| CAUTION | |
|
| ||
Note: The door latch may require ad- |
| Do not connect the millivolt | |
justment as the door gasket mate- | The smoke should be drawn into the draft hood. | wall thermostat wires | |
rial compresses after a few fires | to the 120V wires. | ||
If the smoke is not drawn into the draft hood, | |||
and after glass replacement. Turn |
| ||
the latch catch inward or outward | turn the unit off and check for the cause of lack |
| |
to loosen or tighten. | of draft. |
| |
|
|
| |
12 | . |
| |
Regency U38 ULTIMATE Freestanding Gas Stove | |||
