Remington BV12200A, BV1220DAT owner manual Converting from Blower to Vacuum

Remington electric blower/vac 

Converting from

Blower to Vacuum

WARNING: To Reduce The Risk of Personal Injury or Electric Shock – Disconnect from power source before assembling or changing attachments.

Follow the steps below to convert from blower to vacuum. IMPORTANT: The vacuum will not run unless the vacuum tube assembly is locked into place.

1.Press locking lever on bottom inlet cover and remove bottom inlet cover from blower/vac.Remove blower tube from blower/vac.

2.Slide vacuum tube adapter onto outlet on front of blower/vac housing (see Figure 3-6). Securely connect the draw latch to the vacuum bag adapter (see Figure 3-7).

3.Connect the lower and upper vacuum tubes together (see Figure 3-8). Align the ridge on the bottom tube with the channel on the top tube. Press together until you hear a “snap”.

Figure 3-6: Sliding vacuum tube adapter into place

1

Figure 3-7: Connect draw latch to vacuum bag adapter	Figure 3-8: Conntecting lower and upper vacuum tube
	together

120133