How To Use
Cleaning & Maintenance
All Remington® Nose and Ear trimmers run on one "AA" ALKALINE battery.
Inserting the Battery
1. To open the battery |
| |
1 | ||
compartment, turn | ||
| ||
the base of the unit |
| |
approximately 1/4 |
| |
inch counter clock- |
| |
wise and pull it off. |
| |
|
|
Changing the Heads on the NEDH-2000 and NEDH-2500
The
To change heads:
Your nose and ear trimmer is designed to give you years of comfortable use. To ensure that you get optimal performance from your trimmer, follow these simple cleaning and lubrication tips:
Cleaning Your Trimmer
After each use, brush or blow accumulated hair from the cutting unit.
Rinsing your trimmer
Lubricating the cutters
■After rinsing the unit, apply a drop or two of mineral oil or baby oil to the cutting teeth.
■Don’t apply too much oil, or it may spray.
■Finally, point the trimmer down and away from you, and turn it on. This spreads the oil evenly and expels any excess.
2.Insert the battery into the unit, positive end first.
3.Replace the base and turn it 1/4 inch clockwise to lock it in place.
Battery cautions
■Use of
■Batteries should not be left in the unit if the unit is not in use for long periods.
2
3
Unlocked Locked
1.Turn the trimmer off.
2.Detach cutting head by turning it counter clockwise to the unlocked position and pulling it off.
3.Once the previous head is removed, attach the other head by placing it on top of the unit and turning it clockwise to the locked position.
Locked Unlocked
■ The |
cool or warm water. Just hold the unit’s |
head under the faucet — it is not |
necessary to remove the head first. |
Do not use hot water. |
■ If the trimmer needs additional clean- |
ing, the cutting head can be removed |
by turning it 1/4 inch to the right and |
pulling it off. Then blow out the accu- |
mulated hair or rinse it more thoroughly |
under running water. |
■ Afterward, shake excess water from the |
cutter head, making sure that all parts |
are held together. |
■ Replace the head in the same position |
as it was removed, turning it 1/4 inch |
■To prevent battery corrosion, the unit should be kept in a dry environment.
■Dead batteries should be removed immediately and disposed of properly.
■Do not use recharged batteries with this appliance. The lower voltage in recharged batteries impairs the performance of the cutting unit.
counter clockwise until it locks |
into place. |
!The
4 |
| 5 |
|
|
|