BLOWER OPERATION

IMPORTANT: This blower is for household use only.

WARNING: Read and understand this owner’s manual before operating blower. Make certain you read and understand all Safety Warnings on pages 4 and 5 of this manual. Improper use of this blower can result in severe injury ordeath fromfire,electric shock, or body contact with moving parts.

WARNING: To reduce the risk of electric shock, use only with an extension cord intended for outdoor use, such as SW-A, SOW-A, STW- A,STOW-A,SJW-A,SJOW-A, SJTW-A, or SJTOW-A.

Extension Cords

Make sure your extension cord is in good condition. Inspect extension cords periodically and replace if dam- aged.Whenusinganextensioncord,be sure to use one heavy enough to carry the current your blower will draw. An undersized extension cord will cause a drop in line voltage resulting in loss of power and overheating.

The table below shows the correct size extension cord to use depending on cord length and nameplate ampere rating. If in doubt, use the next larger gauge cord. Thesmallerthegaugenumber,thelarger the cord. To reduce the risk of disconnection of blower from the extension cord during operation, use the cord hitch described in this manual.

Cord Length

AWG Cord Size

25 feet

18 AWG

50 feet

16 AWG

100 feet

14 AWG

150 feet

12 AWG

To reduce the risk of electric shock, this blower has a polarized plug (one blade is wider than the other) and will require the use of a polarized extension cord. The blower plug will fit into a polarized extension cord only one way. If the plug does not fit fully into the extension cord, reverse the plug. If the plug still does not fit, obtain a correct polarized extension cord. A polarized extension cord will require the use of a polarized wall outlet. This plug will fit into the polarized wall outlet only one way. If the plug does not fit fully into the wall outlet, reverse the plug. If the plug still does not fit, contact a qualified electrician to install the proper wall outlet. Do not change the blowerplug,extensioncordreceptacle, or extension cord plug in any way.

Inspect cord often. Replace if dam- aged.

Connecting

Extension Cord

WARNING: Fully seat the extension cord on the inlet plug of blower. Failure to do so could lead to overheating of blower. This could cause a fire that results in personal injury to you or others.

The blower has a built-in extension cord retainer. This cord hitch prevents accidental disconnection of the power cord during use. The cord hitch is molded into the lower rear of the blower housing.

1.Plug extension cord into the inlet plug of appliance (See Figure 3).

2.Create a loop in the extension cord and insert the loop through the cord slot of the blower housing (see Figure 4).

3.Pull the loop tight around the molded cord hitch (see Figure 5).

Figure 3 - Plugging extension cord into inlet plug

Figure 4 - Inserting extension cord loop through cord slot

Figure 5 - Pull extension cord loop tight around molded cord hitch

w

8