CLEANING AND
MAINTENANCE
Continued
3.Press 5/32" round Þle (attached to Þle guide) into groove between top plate and depth gauge on chain. File guide should rest on both top plate and depth gauge (see Figure 15). Note: File at midpoint of guide bar.
4.Hold Þle guide level. Make sure 30° mark on Þle guide is parallel to center of guide bar (see
Figure 15). This will insure that you Þle cutters at 30° angle.
5.File from inside towards outside of cutter until sharp. Only Þle in this one direction (see Figure 15). Note: Two or three strokes with Þle should sharpen cutter.
6.After each cutter is sharpened, move chain for- ward to sharpen next cutter. File all cutters on one side of chain.
7.Move to other side of chain and repeat process.
Filing Cutter Depth Gauges
The cutter depth gauge clearance is reduced as cut- ters are sharpened. After every second or third sharp- ening, reset cutter depth gauges.
1.Place depth gauge tool (.025") Þrmly across top of two cutters. Make sure depth gauge enters slot in depth gauge tool (see Figure 17).
2.Use medium ßat Þle. File depth gauge level with depth gauge tool.
3.Remove depth gauge tool. With ßat Þle, round off front corner of cutter depth gauge (see Fig- ure 18).
After several hand Þlings, have authorized service center or sharpening service machine sharpen chain. This will insure even Þling.
REPLACING SAW CHAIN
Replace chain when cutters are too worn to sharpen or when chain breaks. Only use replacement chain noted in this manual.Always include new drive sprocket when replacing chain. This will maintain proper driving of chain. Note: For proper chain and drive sprocket, see Replacement Parts and Accessories.
STORAGE
If storing Pole Saw for more than 30 days, follow steps below.
1.Remove and clean guide bar and chain. Clean guide bar and chain by soaking in petroleum based solvent or mild soap and water mixture.
2.Dry guide bar and chain.
3.Place chain in container Þlled with oil. This will prevent rust.
4.Wipe a thin coating of oil over surface of guide bar.
5.Wipe off outside of Pole Saw body. Do this with soft cloth dampened with a mild soap and water mixture.
6.Store Pole Saw
¥in a high or locked place, out of childrenÕs reach
¥in a dry place
¥with scabbard over guide bar
TECHNICAL SERVICE
You may have further questions about assembling, operating, or maintaining this product. If so, you can visit our Technical Service web site at www.desatech.com or contact our Technical Ser- vice Department at
DESA Specialty Productsª P.O. Box 90004
Bowling Green, KY
ATTN: Technical Service Specialty Products
When contacting DESA Specialty Productsª, have ready
¥Your Name
¥Your Address
¥Your Phone Number
¥Model Number of Product
¥Date of Purchase (Include copy of receipt for written requests).
REPLACEMENT PARTS AND ACCESSORIES
WARNING: Use only replacement parts and accessories described in this manual. Use of other parts or accessories could damage saw or injure operator.
For original replacement parts and accessories, con- tact your nearest Authorized Dealer or Authorized Service Center for this product. If they can not sup- ply the part or accessory, contact your nearest Parts Central listed on page 36. Each Authorized Dealer, Authorized Service Center, and Parts Central is in- dependently owned and operated.
See pages 34 and 35 for an Illustrated Parts List.
If you need additional referral information, contact our Technical Service Department (see Technical Service, page 19).
In Canada call
Model |
|
Part Number | Description |
Guide bar, 6" (15.2 cm) | |
Chain, 6" (15.2 cm) | |
Drive Sprocket |
111607 | 19 | www.desatech.com |
