Introduction

GETTING STARTED

Start by inserting the battery connector into the mating plug on the T3. Make sure the connector is oriented properly before attempting to insert it. Next, turn the unit on by sliding the power switch into the “ON” position (toward the battery).

After power is applied, the T3 will take approximately ten seconds to load the operating system, the application software, and the user program. This long delay only occurs from a power-down state. During normal use the T3 turns-on instantly from its sleep mode.

The T3 is turned-on by touching any area of the display or any keypad button. If the tilt sensor is enabled, picking up the unit will also turn it on.

7