Renesas M30200T-RPD-E

( 19 / 32 )

Figure 4.3 Circuit of oscillator board OSC-2

Figure 4.3 shows the OSC-2 circuit. Use the circuit constants recommended by the

manufacturer of the oscillator.

* X1: 5.08-mm-pitch 2-pin oscillator IC1: Inverter (Unbuffer)

* X2: 2.54-mm-pitch 2-pin oscillator

* X3: 2.54-mm-pitch 3-pin oscillator

IC1

X1,X2

CLK

Vcc

GND

J1-3

1011 8

IC1

J1-1

J1-2

J1-4

GND

IC1

Contents

Main ( 2 / 32 ) Preface To use the product properly Precautions for Safety: Contents Page Summary Terminology Things to Check When Unpacking Other tool products required for this product: Chapter 1. Precautions for Safety WARNING IMPORTANT CAUTION WARNING Warning for Installation: CAUTION Caution to be Taken for Modifying This Product: Cautions to be Taken for This Product: Notes on the Target System: Notes on PC4701 Emulator Main Units: Note on Abnormal Operation of PC4701 System: Page Notes on MAP References and Settings: Note on Differences between Actual MCU and Emulator: Note on Address 0 Access: Note on Referencing and Setting the Work Area: Note on Changing Settings of the Memory Area: Page Chapter 2. Introduction Chapter 3. Specifications Table 3.1 lists the specifications of M30200T-RPD-E. Table 3.1 Specifications of M30200T-RPD-E Page 4.2 Setting Oscillation Frequency Page Page Page Page Page 5.3 Connection to the Pod Probe Caution Note on Connecting the Cable: Page Page Chapter 7. Maintenance and Guarantee 7.1 Maintenance 7.2 Guarantee 7.3 Repair Provisions 7.4 How to Request for Repair CAUTION Note on Transporting the Product: Chapter 8. Troubleshooting