Renesas M30200T-RPD-E - page 22

( 22 / 32 )

Chapter 5. Connection

5.1 Connection to the Emulator Main Unit

Use the FLX120-RPD 120-pin flexible cable (included with the package) to connect the emulator

main unit and M30200T-RPD-E. Figure 5.1 shows how to connect the emulator main unit and

FLX120-RPD.

Install the FLX120-RPD connector (emulator PC4701 side) on the cable connector of the PC4701.

To insert the FLX120-RPD connector, hold the cover of the connector with the "UPSIDE" label

facing up. Then fix the screws of the cover of the connector.

Figure 5.1 Connecting emulator main unit and FLX120-RPD

Caution

Note on Connecting the Cable:

•Be sure to turn off the power before making connections. Otherwise, the internal

circuits may be damaged.

Contents

Main ( 2 / 32 ) Preface To use the product properly Precautions for Safety: Contents Page Summary Terminology Things to Check When Unpacking Other tool products required for this product: Chapter 1. Precautions for Safety WARNING IMPORTANT CAUTION WARNING Warning for Installation: CAUTION Caution to be Taken for Modifying This Product: Cautions to be Taken for This Product: Notes on the Target System: Notes on PC4701 Emulator Main Units: Note on Abnormal Operation of PC4701 System: Page Notes on MAP References and Settings: Note on Differences between Actual MCU and Emulator: Note on Address 0 Access: Note on Referencing and Setting the Work Area: Note on Changing Settings of the Memory Area: Page Chapter 2. Introduction Chapter 3. Specifications Table 3.1 lists the specifications of M30200T-RPD-E. Table 3.1 Specifications of M30200T-RPD-E Page 4.2 Setting Oscillation Frequency Page Page Page Page Page 5.3 Connection to the Pod Probe Caution Note on Connecting the Cable: Page Page Chapter 7. Maintenance and Guarantee 7.1 Maintenance 7.2 Guarantee 7.3 Repair Provisions 7.4 How to Request for Repair CAUTION Note on Transporting the Product: Chapter 8. Troubleshooting