M3S-UFLA32R
UART Flash Memory Programming Utility
REJ10B0239-0140/Rev.1.40 Mar. 2007 Page 6 of 30
4.1 Startup
Double-click the icon after the M3S-UFLA32R setup is completed.
4.2 Exit
Choose [Exit(X)] from [File(F)] menu.
4.3 Operation Outline of the M3S-UFLA32R
To write to the flash memory, perform the following steps.
1) Connecting Host PC to Target Board
•Connect D-Sub 9 pin connector of the MF-TEN-NINE cable to COM1 of the host PC.
•Connect MF-TEN-NINE cable to the interface cable.
•Connect IC clip of the interface cable to the target board by referring to Table 4.3.1.
Connect to
COM1 of the
Host PC
Target Board
MF-TEN-NINE Cable Interface Cable
Figure 4.3.1 Connection Diagram
Table 4.3.1 Connecting Interface Cable to the Target Board
Interface Cable
IC Clip Color IC Clip Pin Name Destination of the Target Board Connection
Red VCC VCCE power supply
Blue SCLK P87 pin
Yellow RXD P86 pin (RXD1)
Black GND GND pin
Green TXD P85 pi n (TXD1)
2) Setting for FP Pin, MOD0 Pin, and MOD1 Pin
Set FP pin of the target board to "H," MOD0 pin to "H," and MOD1 pin to "L," respectively.
For setting procedure, refer to respective board manuals.
3) Power to the Target Board
Start power supply to the target board.