ResMed 61850/2 manual Reassembling the Headgear, Storage, Disposal

5Assemble the elbow assembly:

a Push the tab of the valve up through the slot in the valve clip (D-7). Ensure that the valve locks into the slot.

b Feed the flap of the valve through the slot in the elbow (D-8).

c Press the valve clip onto the elbow until you hear both sides click into place (D-9).

6Push the inlet tube assembly onto the elbow assembly.

Reassembling the Headgear

If taken apart, the headgear has five parts: headgear straps, left and right upper headgear clips, and two lower clips.

1Attach the upper headgear clips to the mask frame (D-6). The mask incorporates lock-out features to ensure that each upper clip attaches to the correct side of the mask frame.

2Clip the lower headgear clips into the mask frame.

3Lay out the headgear straps, label side down. The label is on the outer side of the headgear. The internal side is smooth, to be comfortable against your face.

4Thread the top (short) straps through the upper headgear clips (E-1, E-2).

5 Thread the bottom (long) straps through the lower clips (E-1, E-2). 6 Check that the headgear is not twisted.

Storage

Ensure that the mask is thoroughly clean and dry before storing it for any length of time. Store the mask in a cool dry place out of direct sunlight.

Disposal

The Mirage Liberty does not contain any hazardous substances and may be disposed of with your normal household refuse.

6