MAINTENANCE
LOG REPLACEMENT
The unit should never be used with broken logs. Turn off the gas valve and allow the unit to cool before opening door to carefully remove the logs. The pilot light generates enough heat to burn someone. If for any reason a log should need replacement, you must use the proper replacement log. The position of these logs must be as shown in the diagram under Log Installation.
Note: Improper positioning of logs may create carbon
DOOR GASKET
If the door gasket requires replacement use 7/ 8" diameter oval door gasket (Part #
LATCH ADJUSTMENT
The door latch may require adjustment as the door gasket material compresses after a few fires and after glass replacement. Turn the adjustable catch to tighten or loosen the latch.
GLASS
REPLACEMENT
Your ULTIMATE stove is supplied with high temperature, 5 mm Neoceram ceramic glass that will withstand the highest heat that your unit will produce. In the event that you break your glass by impact, purchase your replace- ment door from an authorized Regency dealer only, and follow our
Replacement Part #
WARNING: Do not operate appli- ance with glass panels removed, cracked or broken. Replacement of the glass should be done by a li- censed or qualified service person.
Note: Wearing gloves will protect your hands while handling glass.
Panel Glass Replacement
1)Remove the door from the unit and place on a soft surface to prevent scratching.
2)Pull out the door gasket.
3)Remove the nuts holding the glass retainers in place.
4)Remove the glass retainers (sides, top and bottom) and the door catch plate.
5)Replace the glass. The glass must have gasketing around it.
6)Reverse the previous steps, replace the retainers and fasten with the nuts but do not overtighten, as this can break the glass. Note: the door catch plate fits on top of the left side retainer.
7)Put gasket glue on the retainers, but do not put glue on the screws. Replace the door gasket, the two ends butt tight together on the bottom edge of the door.
8)Replace door on the stove and check the seal.
Panel Glass Door Assembly
Wraparound Assembly Door (same glass retainers as the Panel Assembly)
Mitred Glass Replacement
Removing Glass
1)Remove the door from the unit and place on a soft surface to prevent scratching.
2)Pull out the door gasket.
3)Remove the 24 nuts holding the glass retainers in place. Do not remove the nuts underneath the retainers.
4)Remove the door catch plate.
5)Remove glass retainers on sides first (3 each side) then remove two center retain- ers.
Note: Center glass retainers are glued to center glass.
6)Remove glass from extrusions. When re- moving center glass, leave white insula- tion in place.
Installing Glass
1)Install both center and side glass ontoextrusionsas per diagram.
2)Place glass assembly into door frame.
3)Install retainers by placing 1 drop of glue where previously glued and put in place.
4)Install side retainers.
5)Install door catch plate.
6)Install the 24 nuts loosely, do not tighten yet.
30 | Regency U39 ULTIMATE Direct Vent Freestanding Gas Stove |