MAINTENANCE
7)Tighten side panels nuts using the following procedure:
a.tighten top & bottom outside corner nuts
(2)
b.tighten inside nuts (3)
c.tighten top & bottom inside corners (2)
8)Tighten the 10 nuts on center glass retainer.
9)Repeat step 7 for other side panel.
10)Replace new gasket by gluing it in place.
11)Install door onto stove and check the seal.
FAN MAINTENANCE
If your fan requires maintenance or replace- ment, access to the fan is through the plate on the rear wall of the firebox. NOTE: the unit
MUST NOT be operated without the fan access panel securely in place and cor- rectly sealed.
IMPORTANT: These fans collect a lot of dust from within your home. En- sure you maintain these fan mo- tors on a regular basis by vacuum- ing out the fan squirrel cages, around the motor, and around the grills on the back of the stove.
IMPORTANT
Disconnect power supply
before servicing
WARNING:
Electrical Grounding Instructions This appliance is equipped with a three pronged (grounding) plug for your protection against shock hazard and should be plugged directly into a properly grounded
To remove U39 fan:
1)Unplug or disconnect power source to stove.
2)Remove all logs and the rear log support, then remove the 10 screws holding the access panel in place.
3)Unclip the black and white wires from the fan motor.
4)Open both side doors and gently pull the flex pipe away from the center, otherwise the fan can catch on the flex pipe during installation and tear the pipe. Do not tear or damage the flex pipe.
Alternate Fan Access:
If the rear access cover is accessible, it can be removed to provide access to the fan.
5)Lift fan off of the 2 pins, tip back and pull through firebox opening. Disconnect the green ground wire from the right side of the fan as soon as you can reach it.
Replacing U39 Fan:
Reverse the above steps (1 - 5). If necessary install a new gasket before replacing the fan access panel. Make sure the fan wires and the ground wire are reattached.
Hint for pushing fan down onto pins - rub a bit of dish soap on the grommet so it will slide more easily onto the pin. Check to make sure the fan is seated properly on the pins - try to move the fan back and forth, there should be no noise, if there is check that the grommets haven't come loose.
Regency U39 ULTIMATE Direct Vent Freestanding Gas Stove | 31 |
