INSTALLATION
7)Place the Left Top Log
A)02-65
-
PinCutout
8)Place Front Right Log
E)02-45
11)Position notch in Front Right Log
-48
-
Notch
G)02-48
45
FRONT DOOR
INSTALLATION
(packaged separately)
1)Open the two side panels.
2)Slide the door onto the two
hinge pins mak- | i n g | |
sure the | two |
|
pieces | are |
|
flush together. |
| |
See diagram 1. |
| |
3) Close the door. | The |
latch plate must be centered around the alignment pin. See dia- gram 2. If the latch plate interferes with the cor- ner of the stove you may want to angle the
plate slightly so the door closes easier.
4)The latches should already be at the proper setting. If they are too hard or too easy to close, you may want to adjust them by loosening the latch catch. See diagram 3.
9)Place the lava rock in the area between the left and right logs, leaving a space in the middle for log (F)
10)Place the notch in Center Log
-
Bracket
The bottom right edge of Log
12)Test fire to ensure proper light off (make sure flame flows smoothly from one end of burner to the other. If there is any flame hesitation, check that area for any block- age of the burner port.
-
| - | ||
|
| ||
F)02 | - | ||
|
Diagram 2
5)Remove the blue plastic protective coating from the glass.
6)Test the seal around the door by placing a piece of paper between the unit and the door, close the door and try to pull the paper out. If it slips out easily, then the door is not properly sealed. Tighten or loosen the latch. See diagram 3.
Notch Cutout
Diagram 3
Note: The door latch may require ad- justment as the door gasket mate- rial compresses after a few fires and after glass replacement. Turn the latch catch inward or outward to loosen or tighten.
Regency U39 ULTIMATE Direct Vent Freestanding Gas Stove | 25 |