ResMed VPAP Adapt SV manual Treatment Screens, Servicing Menu

Servicing Menu

This menu displays the following information:

•SN—the flow generator’s serial number

•PCB—the flow generator’s PCB number (PCB—printed circuit board)

•SW—the version of software currently installed on the flow generator.

Treatment Screens

There are three Treatment screens displayed in the VPAP Adapt SV LCD. The LCD will display the Treatment screens when treatment commences, and during treatment if no key is pressed for 20 minutes.

Press the QuickView key at any point within a menu to display

Treatment Screen 1. You can return to your original screen if you press the QuickView key again within 20 minutes.

Press the Right key to move from a Treatment screen to the Standby screen. If an alarm is triggered while you are in the Treatment screens, the arrow will flash. Press the Down key until you reach the alarm message.

Scroll through the screens in the usual way, using the Up/Down key.

Treatment mode	Pressure
ASV
	5.0--15.0
			exit
Figure 16: Treatment Screen 1
Leak		Respiratory rate

LK:18L/min RR:12

VT: 428

Tidal volume

Figure 17: Treatment Screen 2

Minute ventilation		Target ventilation
MV:6.2	TARG:5.8
		exit

Figure 18: Treatment Screen 3

Note: TARG is not a relevant parameter in CPAP mode.

24