M219 room amplifier![[A]IR Sensor](/images/new-backgrounds/23934/2393411xi2.webp){kind=small}
Re:connect
M219- Front view
[A] | [B] | [C] |
M219
[A]IR Sensor
The InfraRed sensor receives signals from the remote control or from any other IR control devices, such as the PDAs for the music server.
Switching the IR sensor off
If required, the IR sensor can be switched off using the SETUP DIL switch [3] on the rear of the M219.
[B]Status LED
[C]Ventilation slots
The ventilation slots on the front and the top of the M219 must always be left clear of obstructions.
The M219 should be installed in such a way that the ventilation slots are not covered up and so that there is a gap of at least 5cm between the unit and any walls or furniture.
The blue status LED gives information about the current state of the M219.
| LED display |
|
| M219 Status |
|
|
|
|
| ||
| Permanently dark |
|
| M219 standby mode |
|
| Permanently lit |
|
| M219 active |
|
| Rapid flashing |
|
| Breakdown, overload |
|
| Rapid flashing |
|
| Min/max position reached |
|
|
|
|
| (Volume, Bass, Treble, Balance) |
|
| Slow flashing |
|
| IR receive (RC5 or RC6 Codes) |
|
| Single flash |
|
| LOCAL 1 or general change of source |
|
| Double flash |
|
| LOCAL 2 |
|
| Triple flash |
|
| LOCAL 3 |
|
|
| 5 |
| ||
