![](/images/new-backgrounds/1014052/1405241x1.webp)
WARNING: Field wiring connections and electrical grounding must comply with local codes, or in the absence of local codes, with the latest edition of the National Electrical Code, ANSI/NFPA 70, or in Canada, Canadian Electrical Code, CSA C22.1 Part 1.
NOTICE: Extension cable can be any
Remote Control Installation
Connecting the MAIN | Connecting the remote control to the water |
control to the water heater: | heater: |
wire and need not be polarity sensitive.
Do Not apply sealant to the remote control cable.
It is not recommended to have wiring exposed.
Remote Control
Connection Terminals
PCB
●Drill a 1” (2.5 cm) to
●Install the extension cable between the location of the remote control and the water heater.
●Remove the base plate from the control.
●Feed the remote control extension cable through the central hole in the base plate.
●Fix the base plate to the wall using suitable screws and wall anchors. Ensure the projections on the base plate are pointing upward.
●Connect the remote control cables to the extension cable from the water heater.
●Place the remote control over the
base plate. Ensure the projections in the base plate fit into the housings in the remote control.
● Fix the control to the base plate at the bottom of the remote control using the screw provided.
● Proceed to “Connecting the remote control to the water heater”, to complete installation.
●Ensure that the power to the water heater has been disconnected.
●Remove the front cover of the water heater.
●Insert the remote control extension cable through the hole at the bottom right hand corner of the water heater.
●Connect the wires to the terminals on the top right hand side of the Printed Circuit Board (PCB) as shown in diagram to the left.
NOTICE: The remote control wire connection terminals are not polarity sensitive.
●Firmly tighten the terminal screws.
●Secure the remote control extension cable using the appropriate clamp.
●Replace the front cover of the water heater.
●Switch on the power supply to the water heater.
●Ensure proper operation of the remote control and water heater.
Ground | 18 AWG |
Clamp | Extension |
| Cable Gas Valve |
Projections
Remote
Control
ExtensionWall
CablePenetration
Suitable
Wall Anchors
Control | Base Plate | |
Screw | ||
Screws | ||
|
21