IMPORTANT SAFETY INFORMATION. READ ALL INSTRUCTIONS BEFORE USING.
DANGER!
WATER TEMPERATURE SETTING
Safety and energy conservation are factors to be considered when selecting the water temperature setting . Water temperatures above 125oF can cause severe burns or death from scalding. Be sure to read and follow the warnings outlined on the label pictured below.
Water temperature over 125F can cause severe burns instantly or death from scalds.
Children, disabled and elderly are at highest risk of being scalded.
See instruction manual before setting temperature at water heater.
Feel water before bathing or showering.
Temperature limiting valves are available, see manual.
Output Temp | F |
Set Temp |
|
Error Code |
|
Time/Temperature Relationship in Scalds
Water Temperature | Time To Produce a Serious Burn |
120oF | More than 5 minutes |
125oF | 1 1/ 2 to 2 minutes |
130oF | About 30 seconds |
135oF | About 10 seconds |
|
|
140oF | Less than 5 seconds |
|
|
145oF | Less than 3 seconds |
150oF | About 1 1/ 2 seconds |
155oF | About 1 second |
Table courtesy of Shriners Burn Institute
The chart shown above may be used as a guide
in determining the proper water temperature for your home.
DANGER: Households with small children, disabled, or elderly persons may require a 120oF. Or lower temperature setting to prevent contact with 
HOT
water.
Maximum water temperature occurs while burner is on. To find water temperature being delivered, turn on a hot water faucet and place a thermometer in the water stream and read the thermometer.
The temperature of the water at the outlet of the water heater can be regulated by setting the temperature on control panel . The control panel was set at 110oF before it was shipped from the factory.
The illustration to the bottom left illustrates the control panel and how to adjust the water temperature.
Notice: When this water heater is supplying general purpose hot water requirements for use by individuals, a thermostatically controlled mixing valve for reducing point of use water temperature is recommended to reduce the risk of scald injury. Contact a licensed plumber or the local plumbing authority for further information.
Notice: The factory setting allows operating temperatures between 90oF and 140oF.
DOWNUP ON/OFF
4
