Rhino Mounts FM100 Lubrication Information, Lubrication Fitting Location, Description Frequency

MAINTENANCE

MAINTENANCE

Before operating your Finishing Mower, make sure it is properly lubricated and thoroughly inspected. Only a minimum of time and effort is required to regularly lubricate and maintain this machine to provide long life and trouble free operation.

WARNING! Always disengage the PTO before raising the Rotary Cutter for transporting or making adjustments.

LUBRICATION INFORMATION

Do not let excess grease collect on or around parts, particularly when operating in sandy areas. The illustrations below shows lubrication points. The chart gives the frequency of lubrication in hours, based on normal operating conditions. Severe or unusual conditions may require more frequent lubrication. Figure 1.

Use an SAE multi-purpose, lithium-type grease for all locations shown. Be sure to clean the fitting thoroughly before using grease gun. Failure to maintain proper lubrication will result in damage to U-joints, gearbox, and/ or driveshaft.

1

2	3
5	1
	4

1

3

3

2

2 5

	1
	2
	LUBRICATION FITTING LOCATION FIGURE1
ITEM	DESCRIPTION	FREQUENCY
1	Gauge Wheel Pivots	apply light oil weekly
2	Wheel Hubs	8 Hours or daily
3	Blade Spindle	8 Hours or daily
4	U-Joint Telescoping Member	8 Hours or daily
5	U-Joints	8 Hours or daily
FM100 02/04	Maintenance Section 5-2
© 2004 Alamo Group Inc.