MAINTENANCE

MAINTENANCE

BELT ADJUSTMENT PROCEDURE Figure 7.

Shut off mower and tractor. . Loosen jam nut (item 1) on tension adjustment bolt (item 2). Tighten adjustment bolt (item 3) until belt deflection along front of belt (item 4) is 3/4" with approximately 10 pounds applied to center of length. DO NOT OVERTIGHTEN. Tighten jam nut (item 1).

BELT REMOVAL/INSTALLATION Figure 7.

Gearbox Mount Plate

5

2 1

3

4

Deflection is 3/4" when

applying 10 Lbs of

preasure

FIGURE 7

Shut off mower and tractor. Remove belt shield fasteners and belt shields. Loosen tension on belts as described above. Slip old belts under gearbox mount plate and under center spindle sheave (item 5). Slip new belts under gearbox mount plate and under center spindle sheave ). Feed belts as shown in Figure 7 and tighten belts as described in the Belt Adjustment Procedure. Reinstall shields and shield fasteners.

FM100 02/04

Maintenance Section 5-6

© 2004 Alamo Group Inc.

 

Page 88
Image 88
Rhino Mounts FM100 manual Belt Adjustment Procedure Figure