160
Appendices
17
Error Message Cause and Solution Refer to
Can not —. * Selected option can not be applied to image more than
once, or image was created with different make of camera.
If image was created with different make of camera,
process image using original make of camera.
* “—“ indicates the name of the process that can not be applied.
Bluetooth® related error messages
Error Message Cause and Solution Refer to
Requested file cannot be sent. You attempted to send an image other than still ones
(.JPG). Only still images (.JPG) can be sent.
P.105
Verifying failed. The input passkey did not match the destination device.
Enter the correct passkey.
The passkey was not entered within the time limit. Enter
the passkey again within the time limit.
P.106
Cannot connect. At the start of transfer, the destination device could not be
connected due to one of the following causes. Check the
device status and start again from the beginning.
• Signal no longer reach the destination device.
• The destination device does not exist nearby (about 10 m
(3.3 ft.)).
• The destination device is not active because the power is
off or due to other causes.
• The destination device does not support the Bluetooth®
Profiles required for communication with this camera.
• Inappropriate device was selected for the destination.
P.105
Cannot send. Transfer was interrupted by one of the following causes.
Check the device status and start again from the beginning.
• Signal no longer reach the destination device.
• The destination device can no longer receive a signal.
• There is insufficient space on the destination device.
Wireless LAN related error messagesCommunication and send setting errors
Error Message Cause and Solution Refer to
Connection error The camera is unable to establish a connection for some
reason. Check the communication settings.
P.116,
P.127
Send method must be selected The [Send Method] setting is not selected in the
communication settings. Select [Send via FTP].
P.123
Cannot connect to access point The destination access point is off or otherwise not
operating. Check the access point.
Incorrect communication settings. Check the send settings. P.116