Decide the placement method.
Place the Place the Place the top Place the
original so original so edge of the original so
Place the original.that the top that the top original first. that the top
(There are two original orien- edgetouches edge touchesedge touches
tations.)the top left of the rear ofthe back of
the expo- the exposurethe ARDF. sure glass. glass.
The original displayed on a computer
Exposure glass
An original to be scanned

Setting Originals

Setting Originals

The following explains the procedure for placing originals on the exposure glass and in the ARDF, and setting the scan area and orientation according to how you have set your originals.

To correctly display the top/bottom orientation of the scanned original on a cli-

ent computer, the placement of the original and the settings made on the control 2 panel and scanner driver must match.

Placing Originals

Place originals in one of the two orientations show in the table below.

Important

❒Normally, an original is or , but the table below uses a square original to make orientation easier to understand. Even if the shape of your original is different to that shown in the table, the combination of original orientation and the orientation specified on the control panel or scanner driver does not change.

❖Specifying original orientation and setting originals

ARDF

49