OPERATION
WRONG
Fig. 38
WARNING:
To avoid a kickback and to avoid serious personal injury, never position the concave edge of bowed or warped material against the fence.
CLAMPING WIDE WORKPIECES
See Figure 39.
When cutting wide workpieces, such as 2 in. x 6 in., boards should be clamped with a
WIDE BOARD
Fig. 39
MAINTENANCE
WARNING:
When servicing, use only identical replacement parts. Use of any other part may create a hazard or cause product damage.
GENERAL
Avoid using solvents when cleaning plastic parts. Most plastics are susceptible to damage from various types of commercial solvents and may be damaged by their use. Use clean cloths to remove dirt, carbon dust, etc.
WARNING:
Do not at any time let brake fluids, gasoline, petro-
It has been found that electric tools are subject to accel- erated wear and possible premature failure when they are used on fiberglass boats, sports cars, wallboard, spackling compounds, or plaster. The chips and grindings from these materials are highly abrasive to electric tool parts such as bearings, brushes, commutators, etc. Consequently, it is not recommended that this tool be used for extended work on any fiberglass material, wallboard, spackling compounds, or plaster. During any use on these materials it is extremely important that the tool is cleaned frequently by blowing with an air jet.
LUBRICATION
All of the bearings in this tool are lubricated with a sufficient amount of high grade lubricant for the life of the unit under normal operating conditions. Therefore, no further lubrica- tion is required.
31
