MAINTENANCE
CHECKING/REPLACING EXTERNAL
BRUSHES
See Figure 25.
NOTE: The saw is equipped with externally accessible brushes.
Unplug the saw.
WARNING:
Failure to unplug the tool could result in accidental starting causing possible serious injury.
NOTE: Brush caps (2) are located on each side of the motor housing.
Remove brush caps (2) using a screwdriver.
Remove brush assemblies (2).
Check for wear. Replace both brush assemblies when either has less than 1/4 in. length of carbon remaining.
NOTE: Do not replace one side without replacing the other.
Reassemble using new brush assemblies. Make sure curvature of brush matches curvature of motor and that brush moves freely in brush tube.
Reassemble by reversing the steps listed above.
Tighten all brush caps securely. Do not over tighten.
ACCESSORIES
Look for these accessories where you purchased this product:
| BRUSH |
| CAP |
| BRUSH |
ASSEMBLY | |
45 |
|
30 |
|
22 |
|
15 |
|
BRUSH |
|
ASSEMBLY | |
BRUSH CAP | Fig. 25 |
| |
� Edge Guide | 631697001 |
WARNING:
Current attachments and accessories available for use with this tool are listed above. Do not use any attachments or accessories not recommended by the manufacturer of this tool. The use of attachments or accessories not recommended can result in serious personal injury.
22
