OPERATION
OPERATING THE SAW
See Figures 11, 12, and 13.
It is important to understand the correct method for operat- ing the saw. Refer to the figures in this section to learn the correct and incorrect ways for handling the saw.
WARNING:
To make sawing easier and safer, always maintain proper control of the saw. Loss of control could cause an accident resulting in possible serious injury.
DANGER:
When lifting the saw from the workpiece, the blade is exposed on the underside of the saw until the lower blade guard closes. Make sure the lower blade guard is closed before setting the saw down.
To make the best possible cut, follow these helpful hints.
nHold the saw firmly with both hands.
n Avoid placing your hand on the workpiece while making a cut. See Figure 11.
n Support the workpiece so that the cut is always on your right.
n Support the workpiece near the cut.
n Clamp the workpiece securely so that the workpiece will not move during the cut. See Figure 12.
n Avoid placing the saw on the part of the workpiece that will fall off when the cut is made. See Figure 13.
n Place the workpiece with the “good” side down.
nDraw a guideline along the desired line of cut before beginning the cut.
nKeep the cord away from the cutting area. Always place the cord to prevent it from hanging up on the workpiece while making a cut.
DANGER:
If the cord hangs up on the workpiece during a cut, release the switch trigger immediately. Unplug the saw and reposition the cord to prevent it from hang- ing up again.
DANGER:
Using a saw with a damaged cord could result in serious injury or death. If the cord has been dam- aged, have it replaced before using the saw again.
17
Fig. 11
LINE OF
CUT
Fig. 12
Fig. 13
