RIDGID R3210 manual To Adjust Positive 0 Bevel Stop, To Adjust Bevel Setting, See Figures 16

OPERATION

TO ADJUST POSITIVE 0° BEVEL STOP

See Figures 16 and 17.

nUnplug the saw.

nPull bevel adjustment lever upward to release.

nTurn set screw with hex wrench and adjust base until it is square with the saw blade.

nSecurely lock the bevel adjustment lever.

TO ADJUST BEVEL SETTING

See Figure 16.

nUnplug the saw.

nPull the bevel adjustment lever upward until the motor housing moves freely.

nRaise the motor housing end of the saw until you reach the desired angle setting on the bevel scale (0-45°).

Note: Pull the adjustment lever all the way up to set the angle at 51.5°. To reach the 51.5° bevel setting, push the 51.5° bevel button shown in figure 16.

nPress downward on the bevel adjustment lever until the motor housing is securely locked in place.

BEVEL

ADJUSTMENT

LEVER

51.5° BEVEL

BUTTON

Fig. 16

SET

SCREW

Fig. 17

19