![](/images/new-backgrounds/1331920/33192053x1.webp)
OPERATION
SUPPORTING LONG WORKPIECES
See Figures 34 - 35.
Long workpieces need extra supports. Supports should be placed along the workpiece so it does not sag. The support should let the workpiece lay flat on the base of the saw and miter table during the cutting operation. Use the work clamp or a
NOTE: When making a compound miter cut as shown in figure 34, it may be necessary to adjust or remove the sliding miter fence to insure proper clearance prior to making the cut.
45° x 45° COMPOUND MITER CUT
Fig. 34
LONG
WORKPIECE
WORKPIECE |
|
SUPPORTS | Fig. 35 |
|
CLAMPING WIDE WORKPIECES
See Figure 36.
When cutting wide workpieces, such as 2 in. x 10 in., boards should be clamped with a
WIDE BOARD
Fig. 36
27