OPERATION
CUTTING WARPED MATERIAL
See Figures 40 - 41.
When cutting warped material, always make sure it is positioned on the miter table with the convex side against the fence as shown in figure 40.
If the warped material is positioned the wrong way as shown in figure 40, it will pinch the blade near the completion of the cut.
|
| WRONG |
|
| Fig. 41 |
|
| WARNING: |
RIGHT |
| To avoid kickback and serious personal injury, |
| never position the concave edge of bowed or | |
| Fig. 40 | warped material against the fence. |
|
|
33
