OPERATION
WARNING:
Do not allow familiarity with your
CHARGING BATTERY PACK
The battery pack for this tool has been shipped in a low charge condition to prevent possible problems. Therefore, you should charge it until the light on front of charger changes from flashing green to continuous green.
Note: Batteries will not reach full charge the first time they are charged. Allow several cycles (drilling followed by recharging) for them to become fully charged. This is normal for
TO CHARGE
nCharge battery pack only with the charger provided.
nMake sure power supply is normal house voltage, 120 volts, 60 Hz, AC only.
nConnect the charger to a power supply.
nAttach battery pack to charger by aligning raised ribs on battery pack with grooves in charger, then slide battery pack onto charger. See Figure 2.
nAfter normal usage, 20 minutes of charging time is required to be fully charged.
nThe battery pack will become slightly warm to the touch while charging. This is normal and does not indicate a problem.
nDo not place charger in an area of extreme heat or cold. It will work best at normal room temperature.
nWhen the batteries become fully charged, unplug your charger from power supply and remove the battery pack.
IMPORTANT INFORMATION FOR RECHARGING HOT BATTERY PACK
When using your drill continuously, the batteries in your bat- tery pack will become hot. You should let a hot battery pack cool down for approximately 30 minutes before attempting to recharge. When the battery pack becomes discharged and is hot, the green LED will be off and the red LED will begin flashing.
When the battery pack cools down to approximately 104°F (40°C), the charger will automatically begin fast charge mode.
If the Red LED continues to flash for more than 90 minutes, and the green LED remains off, this may indicate a damaged battery that will not charge.
Fig. 2
IMPORTANTINFORMATIONFORRECHARGING COOL BATTERY PACK
If battery pack is below normal temperature range, the red LED will begin flashing and the green LED will be off. When the battery warms to a temperature of more than 41°F (5°C), the charger will automatically begin fast charge mode.
Note: Refer to "CHARGING BATTERY PACK" for normal recharging of batteries. If the charger does not charge your battery pack under normal circumstances, return both the battery pack and charger to your nearest repair center for electrical check. For the location of your nearest repair cen- ter, please call
CAUTION:
To prevent damage to battery pack, remove battery pack from charger immediately if no LED comes on. Return battery pack and charger to your nearest service center for checking or replacing. Also, if you are removing battery pack from charger and no LEDs are on, return both battery pack and charger to your nearest service center. Do not insert another battery pack into charger. A damaged charger may damage a battery pack.
10
