OPERATION
INSTALLING BITS
See Figure 9.
nLock the switch trigger by placing the direction of rota- tion selector in center position. See Figure 4.
nOpen or close chuck jaws to a point where the opening is slightly larger than the bit size you intend to use. Also, raise the front of the drill slightly to keep the bit from falling out of the chuck jaws.
nInsert drill bit straight into chuck the full length of the jaws as shown in figure 10.
nTighten the chuck jaws on the drill bit.
nTo tighten the chuck jaws on drill bit; grasp and hold the collar of the chuck with one hand, while rotating the chuck body with your other hand.
Note: Rotate the chuck body in the direction of the arrow marked LOCK to tighten chuck jaws.
nDo not use a wrench to tighten or loosen the chuck jaws.
WARNING:
Make sure to insert drill bit straight into chuck jaws. Do not insert drill bit into chuck jaws at an angle then tighten, as shown in Figure 9. This could cause drill bit to be thrown from drill, resulting in possible serious personal injury or damage to the chuck.
REMOVING BITS
See Figure 9.
nLock the switch trigger by placing the direction of ro- tation selector in center position. See Figure 4.
nLoosen the chuck jaws from the drill bit.
nTo loosen: grasp and hold the collar of the chuck with one hand, while rotating chuck body with your other hand.
Note: Rotate chuck body in the direction of the arrow marked UNLOCK to loosen chuck jaws.
nDo not use a wrench to tighten or loosen the chuck jaws.
nRemove the drill bit from the chuck jaws.
UNLOCK
(RELEASE)
LOCK
(TIGHTEN)
Fig. 9
WRONG
Fig. 10
14
